Water Pumps
Lightning Pro.


  Solar Charge Controllers

Victron's full range of solar charge controllers


BlueSolar Charge Controllers

New! BlueSolar Charge controller MPPT 70/15

Ultra fast Maximum Power Point Tracking (MPPT)

Advanced Maximum Power Point Detection in case of partial shading conditions

Especially in case of a clouded sky, when light intensity is changing continuously, an ultra fast MPPT
controller will improve energy harvest by up to 30% compared to PWM charge controllers and by up to 10% compared to slower MPPT controllers.

BatteryLife: intelligent battery management

Resin encapsulated electronics: Protects the electronic components against the environment

Charge current up to 70A and PV voltage up to 150V:

automatically adjust to a 12, 24 or 48V nominal battery voltage



More info


OutBack's industry leading Maximum Power Point Tracking (MPPT) Charge Controllers offer customers the same reliability and durability built into every OutBack product. Innovative solar harvesting and battery charging algorithms allow you to maximize your systems potential and can increase your renewable energy yield by up to 30%


More info



15 & 30 amps at 12/24 or 48 voltsMorningstar's ProStar™ is the world's leading mid-range solar controller for both professional and consumer applications.


TriStar MPPT

45 or 60 amps at up to 150 volts open circuit (Expected Availability October 2009)The TriStar MPPT™ solar controller with TrakStar™ Technology is an advanced maximum power point tracking (MPPT) battery charger for off-grid photovoltaic (PV) systems up to 3kW.



Battery Monitors





More info





The BMV-600 and BMV-602 are our newest high precision battery monitors. The essential function of a battery monitor is to calculate ampere-hours consumed and the state of charge of a battery. Ampere-hours consumed are calculated by integrating the current flowing in or out of the battery.

  • Highest resolution: 10mA (0,01A) with 500A shunt.

  • Lowest current consumption: 1mA.

  • Easiest to wire: the BMV-600 comes with shunt, 10 meter RJ 12 UTP cable and 2 meter battery cable with fuse. No other components needed.

  • Easiest to install: separate front bezel for square or round appearance; ring for rear mounting and screws for front mounting.

    The BMV-602 has a second voltage measurement input. This input can for example be used to measure the voltage of a starter battery.